48000 BTU Ducted Central Air Conditioner, Heat Pump 4 TON + 10KW electric heat

48000 BTU Ducted AHU Central System: 16 SEER. Inverter w/ 48,000 BTU Heat Pump. 48,000 BTU Central air conditioner system. Comes equipped with both condenser and air handler to provide a powerful 4 Ton, self-contained ducted cooling system for areas up to 2000 square feet. Modular 2-piece design allows for easy installation modular configurations with up flow, down flow, counter flow and horizontal positions. 48,000 BTU INVERTER Heat Pump. 18 SEER – AHRI CERTIFIED. Pre-Charged with ECO-Friendly R410A. Indoor Unit – Air Handler. Outdoor Unit – Compressor. Product and Installation Manual. BASIC OVERVIEW: Central AC systems are split between an outdoor unit and indoor air handler and connected to each other by means of refrigerant tubing / electrical cables. The air handler is mounted inside and uses ducts to distribute cooled air to 1 or more areas. The condensing unit comes pre-charged with R410A Freon for a line set up to 25 feet. (connection cables, piping and thermostat control are not included). In these cases, all the plumbing, wiring and connection piping is usually already in place. All you need to do is double check service ports – gauges are compatible, swap out the old system, re-charge the lines and you’re good to go. Although the installation may seem easy to some, certain tools and experience is necessary to complete installation See installation Manuals : Air handler installation – condenser installation. The installation of HVAC systems includes electrical, gas, and refrigerant connections, is generally regulated by a multiple sets of laws, codes and guidelines, at the federal, state and local levels. Further, the failure to properly install HVAC equipment can raise personal safety and performance concerns. Air handler is compatible for either horizontal or vertical installation. 5 Year Compressor – 1 Year on all other Parts Registration card will be sent with unit, this card should be completed by an HVAC technician (installer). Installation of a mini split must be completed by a licensed HVAC (Heating, ventilating, & air conditioning) company to ensure any issues encountered in the future are not due to improper installation / workmanship. Even though mini split setup is below the expertise requirements of central AC systems, these are not “plug-n-play” units that can be properly installed without certain tools any prior HVAC – electrical knowledge. The installation includes electrical, gas, and refrigerant connections and generally regulated by a multiple sets of laws, codes and guidelines, at the federal, state and local levels. The failure to properly install HVAC equipment can raise personal safety and performance concerns. If you receive a damaged or defective product, a replacement unit will be sent out Free of cost. SOMEBODY MUST BE ON SITE TO ACCEPT / SIGN FOR Order.