17 SEER 12000 BTU Ductless Air Conditioner, Heat Pump Mini Split 1 TON with KIT

Thermocore 17 SEER 12,000 BTU AC. 12000 BTU Ductless Mini Split AC: 17 SEER (220VAC). Inverter w/ 12,000 BTU Heat Pump. Brand new for 2018, the T4E17S-H212 12000 BTU – 17 SEER INVERTER Ductless Mini Split air conditioner and Heat Pump from Thermocore provides both cooling & heating in areas up to 600 ft² large. Benefits of this series Include: I-Feel control, low ambient operational temperatures down to 5F, intelligent Control Systems and comes fully charged with R410A. 12,000 BTU INVERTER Heat Pump. 17 SEER – 9 HSPF – 10.9 EER – AHRI CERTIFIED. Pre-Charged with ECO-Friendly R410A. Indoor Unit – Air Handler. Outdoor Unit – Compressor. Digital LCD Remote Control with Follow Me. Installation Kit with 16ft of lineset and wire. Product and Installation Manual. 17 SEER – 9.0 HSPF – AHRI CERTIFIED. Top HVAC Brand:THERMOCORE SYSTEMS. Pre-Charged w/ Eco-friendly R410A Refrigerant. I-Feel / Follow Me Technology Tracks Remote Location. Cross Flow Technology reduces noise output. Complete Install Kit: Lineset, Indoor Wire, Outdoor Wire. Easy Maintenance – Panel Removes for Access. Two-direction Air vane Evenly Distributes Air. 15 Feet Flared Copper Tubing. 15 Feet Pipe Insulation. 15 Feet Electrical Wire Harness. Indoor wall Mounting Bracket. Remote Control Wall Bracket. Wall Hole Block Putty & Insulated Tape. Extend included 16 foot copper lineset to 25-30-40-50-60-75 feet. WHAT IS DC INVERTER? DC Inverter Air Conditioners are the ultimate cooling technology of the HVAC field. They are called “DC inverter” because the alternative current (AC) is converted to Direct Current (DC) then, direct current inverted back to Alternative current with desired frequency. The current supplied through the wall outlet has fixed frequency which is 60 Hertz. Different frequencies supplied to the compressor will result in different running speeds of the compressor. Inverter control systems use Pulse Amplitude Modulation (PAM) that is the most advanced and energy efficient method of inverting the current. DC Inverter AC’s bear special compressors that their speed could be changed by increasing or decreasing the frequency of the supplied power. Therefore, unlike conventional split Air Conditioners Pumps which cycle between on and off repeatedly, the DC Inverter control system will monitor the room temperature and adjust the compressor speed automatically. Conventional compressors turn on and off to maintain the room temperature at desired level. This will result compressor to draw tremendous energy each time it starts up. This will also reduce the life-span of the compressor and other components that are turning on and off. Once a conventional system is running, it runs at its maximum speed, consuming the maximum amount of energy in order to produce the maximum of cooling to maintain the desired temperature. The system will then cycle between on and off in an effort to maintain this temperature. When a DC Inverter compressor initially starts up, it runs with a higher speed to bring the room temperature to desired level rapidly, Once the set temperature is reached, it slows down and adjust its capacity just to counter the heat loss or heat gain of the building. Constant temperature is maintained. BASIC OVERVIEW: The indoor unit is hung like a picture frame approximately 6 – 8 feet above the floor usually on an exterior wall. A 2-3 inch hole must be made behind the indoor unit in the exterior wall to run the refrigerant copper tubing, electrical wires and the condensate drain to the outside unit. The indoor unit and outdoor unit are connected to each other by means of refrigerant copper tubing and electrical cables. The condensing unit comes pre-charged with R410A Freon however, procedures such as conducting leak tests etc. Are still important steps in ensuring proper functioning of a split AC. 5 Year Compressor – 1 Year on all other Parts Registration card will be sent with unit, this card should be completed by an HVAC technician (installer). Installation of a mini split must be completed by a licensed HVAC (Heating, ventilating, & air conditioning) company to ensure any issues encountered in the future are not due to improper installation / workmanship. Even though mini split setup is below the expertise requirements of central AC systems, these are not “plug-n-play” units that can be properly installed without certain tools any prior HVAC – electrical knowledge. The installation includes electrical, gas, and refrigerant connections and generally regulated by a multiple sets of laws, codes and guidelines, at the federal, state and local levels. The failure to properly install HVAC equipment can raise personal safety and performance concerns. If you receive a damaged or defective product, a replacement unit will be sent out Free of cost. SHIPS TO TO BOTH UNITED STATES AND CANADIAN LOCATIONS! Please contact our offices. Provides Flat even surface – Avoids debris obstruction. 25′ Extension kit (1/4 x 3/8). Extend included 12 ft copper lineset to 25 ft. Mount your condenser at any height on an outdoor sidewall. Required when mounting air handler on Interior wall. The item “17 SEER 12000 BTU Ductless Air Conditioner, Heat Pump Mini Split 1 TON with KIT” is in sale since Sunday, June 14, 2015. This item is in the category “Home & Garden\Home Improvement\Heating, Cooling & Air\Air Conditioners & Heaters\Ductless Split System Air Conditioners”. The seller is “hvac-usa” and is located in Warren, Michigan. This item can be shipped to United States.

• Size: 1 tons
• Modified Item: No
• Custom Bundle: No
• Energy Star: Not Compliant
• Model: T4E17S-H212
• Power Source: Electric
• Features: Ductless
• Cooling BTU/Hr: 12000
• Type: Split System
• MPN: Does Not Apply
• SEER: 17
• Brand: Thermocore
• Non-Domestic Product: No
• Cooling Capacity BTU: 12,000 BTU
• Refrigerant: R410a
• Room Coverage Area: 500 to 749 sq ft
• Year Manufactured: 2018
• Voltage: 208/230 V